#567B - Fits: 567A - Extra V-Block Clamp Only
Pricing Notice
Due to evolving trade policies, product prices may be subject to change. For details, please refer to our Terms of Sale. We remain committed to offering competitive pricing and exceptional service.
Terms of SaleHave a Question About a Product?
Our team is here to answer all your questions and provide the detailed information and support you need to make product decisions.
Contact Us#567B - Fits: 567A - Extra V-Block Clamp Only
ManufacturerStarrett
Part #MV7070885
MFG #MV7070885
#567B - Fits: 567A - Extra V-Block Clamp Only
$69.01
/ EAKnowledgeable Product TeamBenefit from our experienced team, ready to assist you with expert product knowledge and ensure a seamless shopping experience.
- Manufacturer Name: L.S. StarrettFits: 567A
-
- Can be used on base, end, and flat on either side as clamp is within outside width of block. Clamp is provided with an adjustable side screw with caps to support block and prevent tilting. Groove at stepped end at right angle to base and is handy for holding shouldered studs, round pins, etc. Hole clearance for drilling and remove dowel pins provided. Block has four 3/8–16 tapped holes, two in base and one on each side to attach angle iron. Angle iron holding block can then be attached to lathe face-plate or held by magnetic chuck. Block made of hardened steel. Sides are ground parallel and the groove central and parallel to sides and base. Size 1–7/8 inches square, base length about 3–1/2 inches.
- Manufacturer Name: L.S. StarrettFits: 567A
-
- Can be used on base, end, and flat on either side as clamp is within outside width of block. Clamp is provided with an adjustable side screw with caps to support block and prevent tilting. Groove at stepped end at right angle to base and is handy for holding shouldered studs, round pins, etc. Hole clearance for drilling and remove dowel pins provided. Block has four 3/8–16 tapped holes, two in base and one on each side to attach angle iron. Angle iron holding block can then be attached to lathe face-plate or held by magnetic chuck. Block made of hardened steel. Sides are ground parallel and the groove central and parallel to sides and base. Size 1–7/8 inches square, base length about 3–1/2 inches.
Pricing Notice
Due to evolving trade policies, product prices may be subject to change. For details, please refer to our Terms of Sale. We remain committed to offering competitive pricing and exceptional service.
Terms of SaleHave a Question About a Product?
Our team is here to answer all your questions and provide the detailed information and support you need to make product decisions.
Contact Us$69.01
/ EA