#453C - 2-1/2'' Length - Die Maker's Square with 32nds & 64ths Graduations

Specifications

Features

‎

• Larger knurled thumb screw locks sliding blades at any position, and smaller one tilts blades at angle
• To set blades, release blade clamp screw, and tilt blade to desired angle by turning small knurled screw
• Blade held in position by tightening clamping screw
• Head and blades hardened and ground
• Offset blade, used where it would be impossible to sight straight blade, protrudes from square about 1–1/2 inches and is 1/8 inch wide
• Both sides of each edge are beveled to give line contact.