Seco Tools | Niagara Cutter N25240 SEL250 Center Cutting Short Length Single End Square End End Mill, 3/4 in Dia Cutter, 1-5/8 in Length of Cut, 2 Flutes, 3/4 in Dia Shank, 5-3/8 in OAL, TiN Coated

Niagara Cutter N25240 SEL250 Center Cutting Short Length Single End Square End End Mill, 3/4 in Dia Cutter, 1-5/8 in Length of Cut, 2 Flutes, 3/4 in Dia Shank, 5-3/8 in OAL, TiN Coated

Have a Question About a Product?

Our team is here to answer all your questions and provide the detailed information and support you need to make product decisions.

Seco Tools

Niagara Cutter N25240 SEL250 Center Cutting Short Length Single End Square End End Mill, 3/4 in Dia Cutter, 1-5/8 in Length of Cut, 2 Flutes, 3/4 in Dia Shank, 5-3/8 in OAL, TiN Coated

ManufacturerNiagara Cutter

Part #803625240

MFG #N25240

Niagara Cutter End Mill, Center Cutting Short Length Single End Square End, Series: SEL250, 3/4 in Diameter Cutter, 5-3/8 in Overall Length, 1-5/8 in Length of Cut, 2 Flutes, 3/4 in Shank Diameter, Right Hand Cutting Direction, 30 deg Helix Angle, Weldon Flat Shank, ANSI Code: SEL250-0.750-E2-S.3-Z2, ISO Code: SEL250.750E2S.3Z2, HSS, TiN Coated

$64.05

/ EA

QTY

Knowledgeable Product TeamBenefit from our experienced team, ready to assist you with expert product knowledge and ensure a seamless shopping experience.

Manufacturer Name: Seco Tools

ANSI Code: SEL250-0.750-E2-S.3-Z2

Cutter Diameter: 3/4 in

Cutting Direction: Right Hand

Finish: TiN Coated

Helix Angle: 30 deg

ISO Code: SEL250.750E2S.3Z2

Length of Cut: 1-5/8 in

Material: HSS

Number of Flutes: 2

Overall Length: 5-3/8 in

Series: SEL250

Shank Diameter: 3/4 in

Shank Type: Weldon Flat

Type: Center Cutting Short Length Single End Square End

High speed steel (HSS) provides good wear resistance, it is commonly used for general purpose applications on both ferrous and non-ferrous materials
Titanium nitride (TiN) is a multi-purpose coating which increases chip flow in softer materials and the heat and hardness resistance allows the tool to run at higher speeds than uncoated tools
90 deg cutting edge
2.031 in L minimum clamping
30 deg axial rake
10 deg radial rake
3-11/32 in L reach
0.63 in Dia neck
Two flutes offer better chip-carrying capacity than end mills with more flutes, enhancing the tools ability to remove material
Square nose end mills create sharp, unrounded cuts
Extended-reach neck style provides access to recessed areas of the workpiece
E - Neck tool shape

Catalog